Joined: Jun 2014. 3 04-18-2018, 10:55 AM. (04-18-2018, 12:18 AM)KIR73 Wrote: It's well known problem. The display unit is CAN gate for Climate control. Climate control ecu has no ignition wire it powers after can command. No display - no gate no can command and climate ecu simply didn't know tha ignition is on.
Step 2: Start the Engine. Start the engine and set the heater temperature control inside the car to high and the blower motor fan on low. This allows the coolant to reach operating temperature faster by not removing heat from coolant through the heater core. Let the engine run.
Note: Replace blower motor if required. Dry heater housing inner side. - see working procedure "Blower Motor Replacement — Right Hand Drive", group "HVAC/Heating, Ventilation, and Air Conditioning", Service Instruction Astra-J (Document Number 92293574) 3. Remove blower motor control module and check for water traces
Remove the windscreen wipers. Remove the scuttle panel. Remove the pollen filter by releasing the 2 retaining clips. Undo the 2 retaining screws holding the resistor pack in place. Now fit the new resistor pack, and replace everything in reverse order. That should cure your heater problems.